How to make a 12V 10Ah motorcycle starter battery with 10Ah lithium polymer cells?

How to make a 12V 10Ah motorcycle starter battery with 10Ah lithium polymer cells?

The engineer teaches you to use a 3.7V 10Ah lithium polymer battery to make a 12V 10Ah motorcycle starting battery.How to make a 12V 10Ah motorcycle starter battery with 10Ah lithium polymer cells?

2021/02/22
SEND INQUIRY NOW
CONTACT US
Telephone: 0086-755-23460581
Send your inquiry

Engineer production steps:


Step 1: Check the battery cells, use the tester to test the voltage of the 3 battery cells, and record the data


Step 2: Fix the 3 batteries side by side with 3M glue


Step 3: Solder and fix the prepared PCB (battery protection board) to a suitable position on the top of the battery pack, and check the solder joints


Step 4: Test again the battery pack voltage after installing the protection board


Step 5: Weld the two wires to the positive and negative solder joints of the battery pack PCB respectively


Step 6: Insulate with Highland Barley paper


Step 7: Install the insulated battery pack into the prepared ABS shell


Step 8: Fix the battery pack with glue


Step 9: Reinforce the battery pack with high temperature and fireproof epoxy board


Step 10: Weld the positive and negative terminals


Step 11: fix the shell cover with a glue gun to package.


Step 12: Use a comprehensive tester to test battery voltage and discharge


12v 10Ah lithium battery 12v battery 12v lithium battery DIY 12v battery
IF YOU HAVE MORE QUESTIONS,WRITE TO US
Just tell us your requirements, we can do more than you can imagine.

Send your inquiry